Salam hörmətli istifadəçilər! Mən "bad sector" haqqında internetdə biraz məlumat əldə etmişəm. Ancaq təəssüflər olsun ki, Azərbaycan-dilində o qədər geniş məlumat tapa bilmədim. Suallarım isə belədir? 1) Hard disk-də "bad sector" olarsa, onu hansısa üsulla və ya proqramla düzəldib, problemi 100% aradan qaldırmaq olar? 2) Hard disk-də "bad sector" aşkar olunsa, mütləq "Hard disk" dəyişdirilib, yenisi ilə əvəz olunmalıdırmı? Xahiş edirəm ətraflı cavab yazasınız!
(2013-10-16 23:27:53)
soft bad sector yeni texnologiyadir deyesen..nese ilk defe esidirem..
A bad sector is a sector on a computer's disk drive or flash memory that cannot be used due to permanent damage (or an OS inability to successfully access it), such as physical damage to the disk surface (or sometimes sectors being stuck in a magnetic or digital state that cannot be reversed) or failed flash memory transistors. It is usually detected by a disk utility software such as CHKDSK or SCANDISK on Microsoft systems, or badblocks on Unix-like systems. When found, these programs may mark the sectors unusable (all file systems contain provisions for bad-sector marks) and the operating system skips them in the future.
If any of the files uses a sector which is marked as 'bad' by disk utility then the bad sector of the file is remapped to a free sector and any unreadable data is lost. To avoid file corruption data recovery methods should be performed first if bad sectors are found (before being marked) by OS at file system level.
When a sector is found to be bad or unstable by the firmware of a disk controller, the disk controller remaps the logical sector to a different physical sector. In the normal operation of a hard drive, the detection and remapping of bad sectors should take place in a manner transparent to the rest of the system and in advance before data is lost. It should be remembered, however, that the damaging of the physical body of the hard drive does not solely affect one area of the data stored. Very often physical damages can interfere with parts of many different files.
There are two types of remapping by disk hardware: P-LIST (Mapping during factory production tests) and G-LIST (Mapping during consumer usage by disk microcode).[1]
There are a variety of utilities that can read the SMART information to tell how many sectors have been reallocated, and how many spare sectors the drive may still have.[2] Because reads and writes from G-list sectors are automatically redirected (remapped) to spare sectors it slows down drive access even if data in drive is defragmented. If the G-list is filling up, it is time to replace the drive.[3]
Typically, automatic remapping of sectors only happens when a sector is written to. The logic behind this is presumably that even if a sector cannot be read normally, it may still be readable with data recovery methods. However, if a drive knows that a sector is bad and the drive's controller receives a command to write over it, it will not reuse that sector and will instead remap it to one of its spare-sector regions.[citation needed] This may be the reason why hard disks continue to have sector errors (mostly disk controller timeouts) until all the bad sectors are remapped; typically this is accomplished by writing zeros to the entire drive. See the SMART attribute number 197 ("Current Pending Sector Count") for more information.[4]
menbe wikipedia...
bad sectorlari ve ya badbloklari nece partitiona bole bilersiz eger heresi ferqli sectorda yerlesibse hard diski 1000 partitiona bolecekdiz? windowsun partition limiti var xatirladim ki..
(2013-10-16 02:33:01)
1) bad sector iki növdə olur, hard və soft. hard fiziki zədədir, soft qeyri-fiziki ), fiziki zədə ört bastır yolu ilə düzəldilir. qeyri-fiziki isə 0-lanır. vvindovsun özünün standart proqramı var bunun üçün aşağıdakı linkdə baxa bilərsiniz, şəkil çəkmişəm.
burada
2) Hard diski dəyişmək vacib deyil. bərpa etmək mümkündürsə bərpa etmək, yox əgər fiziki zədədirsə həmin hissəni bir partition kimi ayırmaq olar və həmin partitiondan istifadə etməmək olar.
(2013-10-15 22:15:39)
1) Xeyr bad sector hec bir halda berpa oluna bilmez. Cunki bu fiziki zededir.. proqram teminati ile uzerini baglamaq olur deyilir ancaq men bunu real saymiram..
2)Harda diskin deyishilmeyi mutleq deyil demek duzgun olmazdi bu Bad sectorlarin sayindan asilidir.. Muasir emeliyyat sistemleri bad sector olan diskde ishleye bilir.. Ancaq sayi coxaldiqca artiq komp donur sistemde problemler olur ve s.